Open now
Veteran Owned & Operated · Licensed, Bonded & Insured · AZ ROC 350424

Home/ Blog/ Heating repair

Heating repair ยท Prescott Valley · November 17, 2026

Heating Repair in Prescott Valley: What to Check When Your Heater Won't Turn On

Prescott Valley nights drop below freezing fast in late fall, and that is when tired heating parts give out. Before you call, here are the safe checks that fix a surprising number of no-heat problems, what the common symptoms usually mean, and when it is time for a technician.

(928) 565-6440

Smell gas or hear the CO alarm? Start here

If you smell gas or a carbon monoxide alarm is going off, do not troubleshoot anything. Get everyone out of the house, then call your gas utility or 911 from outside. Do not flip switches or relight anything. Once the utility or fire department says it is safe, call us and we will find out why.

Why heaters quit on the first real cold nights in Prescott Valley

Prescott Valley sits a little over 5,000 feet up. The days can be mild, but the nights in late fall and winter regularly drop into the twenties, and a cold snap can push lower. That means your heater sits idle most of the summer and then gets asked to run long, hard cycles almost overnight. Parts that were already weak, like a tired igniter, a dirty flame sensor or a capacitor on the inducer motor, tend to give out right when the heat is needed most.

Most homes here heat with one of three setups: a gas furnace in a closet, garage or attic, a heat pump with an indoor air handler, or a gas package unit sitting outside on a pad. Many neighborhoods were built in the same few decades, so a lot of equipment is reaching the same age at the same time. If you are still running the original system, our guide to builder-grade HVAC in Prescott Valley tract homes explains what usually wears out first.

Heat pump outdoor unit on a gravel side yard with a thick column of ice built up against its coil

Safe checks you can do before you call

These take a few minutes, need no tools and do not involve opening the equipment.

  1. Check the thermostat. Make sure it is set to Heat, not Cool or Off, and set a few degrees above the room temperature. If the screen is blank or dim, replace the batteries.
  2. Check the breakers. A furnace or air handler has its own breaker, and a heat pump has a second one for the outdoor unit. If one is tripped, reset it once. If it trips again, leave it off and call us. Repeated resets can damage the equipment.
  3. Find the furnace service switch. It usually looks like a light switch on or near the furnace.
  4. Look at the filter. A packed filter can make a furnace overheat and shut itself down on its high limit switch, which looks like a heater that runs for a few minutes and quits.
  5. Make sure the furnace door is seated. Most furnaces have a safety switch behind the lower panel. If the panel is loose, the furnace will not start.
  6. Check the vent pipes outside. High-efficiency furnaces use white plastic pipes through a wall or the roof. After snow or a hard freeze, look from the ground for snow or ice blocking the ends. If you can safely clear a wall vent by hand, do it. Do not climb onto an icy roof.
  7. Clear the outdoor unit. On a heat pump or package unit, keep snow, leaves and brush cleared away from the sides and top.
  8. Count the blinking light. Many furnaces have a small window with a status light on the control board. Write down the pattern before you call. It helps us arrive with the right parts.

What the common symptoms usually mean

  • Nothing happens at all. Often power, the thermostat, a blown low-voltage fuse or a failed control board or transformer.
  • You hear the inducer motor hum, but no flame. Commonly a pressure switch, a blocked vent or condensate drain, or a cracked or worn-out igniter.
  • Flame lights, then shuts off after a few seconds. Very often a dirty or failing flame sensor. It is one of the most common first-cold-night calls.
  • Runs for a few minutes, then quits. Usually airflow: a dirty filter, a dirty blower wheel, closed vents or a failing blower motor tripping the high limit.
  • Heat pump runs but blows cool air, or the outdoor unit is a block of ice. A little frost is normal and the unit should defrost itself every so often. A thick ice block that never clears points to a defrost control, sensor, outdoor fan or refrigerant problem.
Inside an older gas furnace with the panel off, showing the gas valve, wiring and inducer motor
Outdoor electrical disconnect box with a surge protector mounted on a stucco wall

When to stop and call

Call us if a breaker trips a second time, if the furnace lights and shuts off over and over, if you see soot or scorch marks, if there is water pooling around a high-efficiency furnace, or if a burning smell does not fade after the first few minutes of the season. A little dusty smell on the first run is normal. A smell that lingers is not. Our post on furnace burning smells covers the difference.

Heat pump homes should also call if the system is living on emergency or auxiliary heat for days. It keeps the house warm, but it costs a lot more to run, which is the subject of our post on high winter heat pump bills.

What happens when we come out

You get the service call price on the phone, before anyone heads your way. The diagnostic is credited toward the repair when you approve it. When our technician arrives, we test instead of guess: gas pressure, igniter and flame sensor readings, inducer and pressure switch operation, temperature rise across the furnace, capacitor and motor readings, and on heat pumps the defrost controls, refrigerant pressures and backup heat.

You see the numbers and get a plain explanation of what failed and what it takes to fix. Common parts like igniters, flame sensors, capacitors and contactors ride on the truck, so many heating repairs get done on the first visit. If a part has to be ordered, we tell you how long it will take and keep you posted, instead of leaving you guessing.

If your system is old enough that repair stops making sense, we will say so honestly and lay out repair and replacement side by side, with no pressure to decide that day. Replacement estimates are free, and as a Trane Comfort Specialist we can quote Trane furnaces and heat pumps sized for your home. Financing is available on approved credit. For help weighing it, read repair or replace your furnace in Prescott Valley.

Keep the next cold snap from catching you

Most of the failures above give warning signs a technician can catch on a calm day. A seasonal tune-up cleans the burners and flame sensor, tests the electrical parts and safety controls, and checks airflow before the coldest weeks. Our tune-up is $79, limited time $69 through December 31, 2026. If you would rather keep it on a schedule, our maintenance plans include priority scheduling.

Common questions

Why does my furnace light and then shut off after a few seconds? The most common cause is a dirty or failing flame sensor. The furnace lights, cannot confirm the flame, and shuts the gas off for safety. A blocked vent, a weak pressure switch or low gas pressure can cause the same thing, so it is worth having it tested instead of resetting it over and over.

My heat pump outdoor unit is covered in ice. Is it broken? Light frost on cold, damp mornings is normal, and the unit should run a defrost cycle to clear it. If the coil stays packed with ice for hours or the unit is a solid block, something is wrong with the defrost control, a sensor, the outdoor fan or the refrigerant charge. Turn the system to emergency heat if you have it and call us. Do not chip the ice off.

What does a heating repair service call cost in Prescott Valley? You get the service call price on the phone, before anyone heads your way. The diagnostic is credited toward the repair when you approve it, and you approve the repair price before any work starts.

Can someone come out the same day? A live person answers 24 hours a day, Monday through Saturday, and we give you an honest arrival window when you call. During a cold snap the schedule fills fast, so we will tell you straight when we can be there. Maintenance plan members get priority scheduling.

Should I repair or replace an older furnace that quit? It depends on what failed, not just the age. An igniter or flame sensor on an older furnace is usually worth fixing. A cracked heat exchanger or repeated major failures is a different conversation. We show you the readings, give you both options, and replacement estimates are free with no pressure to decide that day.

Air-Exx Heating Cooling and Ventilation LLC is a veteran-owned company providing heating repair and furnace repair in Prescott Valley, Prescott, Chino Valley and the rest of Yavapai County, plus Mohave County. A live person answers 24 hours a day, Monday through Saturday. Heater won't turn on? Call (928) 565-6440 or text (928) 227-8441 and we will get your heat back on in Prescott Valley.

Straight answers, no surprises

You'll know the price before we start.

You get the service call price on the phone, before anyone heads your way. The diagnostic is credited toward the repair when you approve it.

(928) 565-6440 Request a Quote