Open now
Veteran Owned & Operated · Licensed, Bonded & Insured · AZ ROC 350424

Home/ Blog/ Commercial

Commercial ยท Kingman · November 21, 2026

No Heat at Your Business? A Kingman Guide to Rooftop Unit Heating Repair

The store, office or restaurant is cold at opening time and the rooftop unit will not make heat. Here is why commercial heating fails on the first cold mornings in Kingman, what you can safely check from the ground, and when to call.

(928) 565-6440

Cold building, open for business

The first truly cold mornings in Kingman bring a certain kind of call. The owner or manager unlocks the door at 7 AM, the thermostat says 54, and customers or staff are due in an hour. The rooftop unit hummed along all summer on cooling, but the first time it has to make heat, something does not light, does not stay lit, or blows cold air.

This month our technicians have been out on commercial diagnostic calls in Kingman as the weather turned. Most stores, offices and restaurants here heat with a rooftop package unit, usually gas, sometimes a heat pump. This guide covers why those units fail on the first cold days, what you can safely check from the ground, and when to call for commercial heating repair.

Dual-port digital manometer measuring gas pressure at the gas valve of a commercial heating unit

Why rooftop units fail on the first cold mornings

A rooftop unit spends six or seven months cooling in Kingman, and the heat section sits idle through the heat, wind and dust. A few problems show up again and again:

  • Ignition problems. A dirty flame sensor or a worn hot surface igniter is the classic "lights, then shuts off" or "tries and gives up" complaint.
  • Burners and flue passages. Birds, insects and dust find their way into burner tubes and the vent hood over the summer. A partial blockage can trip a rollout or pressure switch and lock the heat out.
  • Gas pressure and the gas valve. Low or unstable gas pressure gives weak, lazy flames and short heating cycles. A valve that sticks or fails to open gives no heat at all.
  • Inducer motor and pressure switch. The small fan that pulls combustion gases through the unit has to prove airflow before the burners light. A worn inducer or a cracked hose stops the sequence before it starts.
  • Belts and blowers. Many larger units use a belt-drive blower. A belt that stretched or cracked over a long cooling season slips, squeals or snaps, and the heat never reaches the space.
  • A stuck economizer. If the unit has an economizer, the outside air damper should close down in cold weather. One that sticks open pulls cold air straight into the building, and the heat section cannot keep up.
  • Controls and schedules. A power blip can reset a programmable thermostat into the wrong mode or an unoccupied schedule.
Open commercial HVAC control panel showing contactors, a transformer and control wiring during service

Safe checks before you call

If anyone smells gas or rotten eggs inside the building, stop here. Get people out, do not flip switches, and call the gas utility from outside. If a carbon monoxide alarm sounds, clear the building and call 911. Then call us. Otherwise, these checks are safe and do not involve climbing on the roof:

  1. Check the thermostat or control. Make sure it is set to Heat (or Auto), the setpoint is above the room temperature, and it is in the occupied schedule or a temporary override. Replace the batteries if the display is blank or dim.
  2. Check the breaker. Look for a tripped breaker labeled for the rooftop unit in your electrical panel. Reset it once. If it trips again, leave it off and call.
  3. Check whether it is one unit or all of them. If only one zone is cold, tell us which area.
  4. Write down what you see. Note any error code on the thermostat, whether air is blowing from the vents (warm, cool or nothing), and whether the problem started after a power outage or storm.
  5. Look for kitchen or exhaust changes. In restaurants, a hood exhaust running without makeup air can pull cold air in through every door gap and make a working heater look like it is failing. Mention it when you call.

Please do not send an employee up a ladder to open the unit. Rooftop units carry high voltage and a live gas supply, roofs get icy in the morning, and access panels hide sharp edges. That part is our job.

When to call right away

  • The heat starts, then shuts off over and over.
  • You hear a loud bang or rumble when the burners light, or you see scorch marks near the unit.
  • The unit blows cold air in heat mode.
  • Any gas smell or CO alarm, after everyone is out of the building.

What our technicians do on a commercial heating call

You get the commercial service call rate on the phone before we dispatch, and we give you a real arrival window. If that window changes, we call. On the roof, the technician works through the heating sequence with meters instead of guesses:

  • Checks the call for heat from the thermostat and the unit control board, and reads any fault codes.
  • Tests the igniter and flame sensor and watches the burners light and hold.
  • Measures gas pressure at the valve with a manometer and inspects the burners, flue and vent hood.
  • Tests the inducer motor, pressure switch, limit and rollout switches.
  • Checks the blower motor amp draw, the belt and pulleys, and the filters.
  • Checks the economizer damper and its controls.
  • Inspects the heat exchanger area and checks for carbon monoxide in the supply air.

You see the readings and what failed before anything is done. Nothing gets replaced without your approval, and we do not bundle parts that tested fine. If a part is specific to your unit and has to be ordered, we tell you how long it will take and what we can do in the meantime. Our commercial HVAC and refrigeration page covers the rest of the equipment we work on.

Dust-covered belt-drive blower and pulley found inside a commercial unit during a maintenance visit

Repair it, or replace the rooftop unit?

Most no-heat calls end in a repair. But an aging unit with a cracked heat exchanger, a failing compressor or rust through the base can cost more to keep alive than to replace. When that is where things stand, we lay out repair and replacement side by side with no pressure to decide that day.

Replacement estimates are free. As a Trane Comfort Specialist we install Trane equipment and quote replacements in three tiers side by side, and we service existing units of any brand. Before you sign, we walk you through the timeline, including equipment lead time, crane scheduling and any permit, so nothing about the day of the swap is a surprise. Financing is available on approved credit.

Prevent the next cold morning

A fall heating check finds the dirty flame sensor, the cracked belt, the stuck economizer and the weak inducer before the first cold snap does. Our commercial maintenance agreements include scheduled visits, written condition reports and priority dispatch, so most problems land on a planned visit instead of a busy Monday morning. Ask about agreements when you call, or see our maintenance plans page.

If your business also runs coolers or freezers, our guide to a walk-in cooler not holding temperature in Kingman covers that side. For gas furnaces at home with the same lights-then-shuts-off symptom, see furnace keeps shutting off in Kingman.

Common questions

Why does my rooftop unit cool fine but not heat? Cooling and heating use different parts. The heat section of a gas rooftop unit has its own igniter, flame sensor, gas valve, inducer motor and safety switches, and it sits idle all summer. Dust, worn igniters, dirty flame sensors and blocked burner tubes or vents are the most common reasons it will not heat on the first cold days.

Is it safe to keep running a rooftop unit that keeps shutting off on heat? Not for long. Repeated lockouts usually mean a safety switch is doing its job, often because of an ignition, airflow or venting problem. Leave the heat off if it keeps cycling, and have it checked. If anyone smells gas or a CO alarm sounds, clear the building first.

What does a commercial heating service call cost? You get the commercial service call rate on the phone before we dispatch. Any repair is priced and approved by you before the work is done, and nothing gets replaced without your OK.

Do you work on rooftop units of any brand? Yes. We service existing rooftop units, split systems and package units of any brand. When replacement is the better call, we install Trane as a Trane Comfort Specialist and quote it in three tiers side by side. Replacement estimates are free.

Do you offer maintenance agreements for Kingman businesses? Yes. Commercial maintenance agreements include scheduled visits, written condition reports and priority dispatch, so a failing part shows up on a planned visit instead of at opening time. Call (928) 565-6440 to set one up.

Air-Exx Heating Cooling and Ventilation LLC is a veteran-owned heating, cooling and refrigeration company based in Kingman, serving businesses and homes in Golden Valley, Bullhead City and across Mohave and Yavapai counties. A live person answers 24 hours a day, Monday through Saturday. Building cold and the rooftop unit will not heat? Call (928) 565-6440 or text (928) 227-8441 to book commercial heating repair in Kingman.

Straight answers, no surprises

You'll know the price before we start.

You get the service call price on the phone, before anyone heads your way. The diagnostic is credited toward the repair when you approve it.

(928) 565-6440 Request a Quote