Open now
Veteran Owned & Operated · Licensed, Bonded & Insured · AZ ROC 350424

Home/ Blog/ Maintenance

Maintenance ยท Bullhead City · November 18, 2026

Heat Pump Tune-Up in Bullhead City: The Winter Check After a Long, Hot Summer

In Bullhead City the same heat pump that cooled you through a 115 degree summer now has to heat the house. Here is what a winter heat pump tune-up checks, what a long summer does to the parts, and when to call for repair instead.

(928) 565-6440

Why a Bullhead City heat pump needs a check right now

Out here a heat pump works harder than almost anywhere in Arizona. From May into October it runs as an air conditioner through afternoons that climb well past 110 degrees, often for most of the day. Then the river valley cools off, winter nights slip into the 30s and 40s, and that same machine flips over and becomes your heater. There is no real off season for it.

That is why the fall and early winter visit matters so much in Bullhead City. A summer like ours bakes capacitors, pits contactor points, packs the outdoor coil with dust and wears on the fan motor. None of that always shows up as a breakdown in August. A lot of it shows up on the first cold morning, when the system is asked to switch modes, run a defrost cycle and lean on its backup heat for the first time in months. A heat pump tune-up now catches the parts that summer already wore down, before they leave you without heat.

A lot of homes here, including many manufactured homes and homes with the equipment on a pad beside the house, run on a heat pump package unit: the whole system in one cabinet outside. Split systems with an outdoor unit and an indoor air handler are common too. The checks below apply to both.

Outdoor coil being rinsed with a hose on a package unit beside a manufactured home

What we check on a heat pump tune-up

A tune-up is not a quick look and a sticker. Our technicians take readings and show you the numbers. On a heat pump that includes:

  • Electrical parts. Capacitors tested against their rating, contactor points inspected, wiring and connections checked for heat damage, and amp draw on the compressor and fan motors measured against spec. This is where most summer damage hides.
  • Heating mode. We run the system in heat and confirm the reversing valve switches over cleanly and the supply air temperature is where it should be.
  • Defrost controls. In heat mode the outdoor coil can frost up on damp, cold mornings. We check that the defrost control and sensor clear it the way they are supposed to.
  • Backup heat. Most heat pumps have electric heat strips for the coldest mornings. We test them and check that they come on only when they should. Strips that run all the time keep the house warm and run up the electric bill.
  • Refrigerant performance. A refrigerant level check, because a system that is low on charge loses heating capacity and works the compressor harder.
  • Coils and airflow. Outdoor and indoor coil cleaning, filter rack cleaning, and an airflow test so the system is not choking on dust.
  • Drain and thermostat. Drain line flush and a thermostat check, including calibration where the thermostat allows it.
  • Safety inspection. A full look at the cabinet, electrical compartment and disconnect so nothing is loose, burned or open to the weather.

If something is drifting out of spec, you will see the reading and get a straight answer on how long you likely have. You decide what to do about it. Nothing is replaced without your OK.

Close-up of a worn contactor with pitted, burned contacts inside an outdoor unit electrical panel
Thermal camera screen showing a 110.1 degree reading on a refrigerant line during a system check

What a long Bullhead summer does to the parts

Heat is hard on electrical parts. A run capacitor that tested a little weak in spring can be well below its rating by November. A contactor that has opened and closed thousands of times in triple-digit heat gets pitted and burned contacts, and eventually it either sticks or stops pulling in. Those are small, inexpensive parts compared to what they protect. A failing capacitor makes the compressor and fan motor work harder every time they start.

Dust is the other half. Wind and monsoon storms drive fine dust into the outdoor coil, and a packed coil makes the system run longer in both modes. Indoors, a dirty filter or blower slows airflow, and in heat mode that can make a heat pump shut itself down on high pressure. Our post on what SEER2 means for a Bullhead City AC explains why a system only delivers its rated efficiency when it is clean and set up right.

Safe checks you can do between visits

None of these involve opening the equipment.

  1. Change or check the filter monthly during windy stretches. If it is gray and packed in a few weeks, mention it on the visit.
  2. Keep the outdoor unit clear. Two feet of space around the cabinet, nothing stored on top, and no weeds or tumbleweeds packed against the coil.
  3. Set the thermostat and leave it. Cranking it up several degrees at once can call for backup heat. Small changes keep the heat pump doing the work.
  4. Watch for the emergency or auxiliary heat light. If the thermostat shows it running most of the day on a mild night, something needs a look.
  5. Notice the frost. Light frost that clears on its own every so often is normal. A coil that turns into a block of ice is not.

When to skip the tune-up and call for repair

A tune-up is for a system that is running. Call for a repair visit instead if the heat pump is blowing cool air for long stretches in heat mode, the outdoor unit is iced solid, a breaker trips more than once, you hear grinding or loud buzzing outside, or the outdoor fan is not spinning while the unit runs. Our guide to a heat pump blowing cold air covers what those symptoms usually mean, and heating repair in Bullhead City walks through the no-heat checks.

When you call, you get the service call price on the phone before anyone heads your way, and the diagnostic is credited toward the repair when you approve it.

Is it time to replace instead?

Sometimes the tune-up readings tell a bigger story: a compressor pulling high amps, a coil with leaks, or a system old enough that repairs keep stacking up. If that is where yours is, we will tell you honestly and lay out repair and replacement side by side, with no pressure to decide that day. Replacement estimates are free. As a Trane Comfort Specialist we can quote Trane heat pumps and package units sized for your home. Financing is available on approved credit.

Tune-up price and maintenance plans

Our seasonal tune-up is $79, limited time $69 through December 31, 2026. If you would rather not think about it again, our maintenance plans schedule the visits for you, one before summer and one before winter, with a discounted or waived diagnostic, a discount on repairs and priority scheduling when something does go wrong. In a town where the heat pump never really gets a break, two visits a year is the schedule that fits.

Common questions

How often should a heat pump in Bullhead City get a tune-up? Twice a year is the schedule that fits here: once in spring before the cooling season and once in fall or early winter before the heating season. A heat pump in Bullhead City runs in both modes, so one visit a year leaves half of its work unchecked.

How much is a heat pump tune-up? Our seasonal tune-up is $79, limited time $69 through December 31, 2026. Maintenance plan members get their visits scheduled as part of the plan.

My heat pump worked fine all summer. Does it still need a winter check? Yes. Summer is when the electrical parts and the outdoor coil take the most wear, and heating mode uses parts that sat idle all summer: the reversing valve, the defrost controls and the backup heat. A system that cooled fine in August can still struggle the first cold morning.

Why is my outdoor unit steaming or frosting up in the morning? Light frost on a cool, damp morning is normal in heat mode, and the steam you see is the defrost cycle melting it off. If the coil stays covered in thick ice for hours, or the unit never seems to defrost, call us. Do not chip the ice off.

Do you work on heat pumps that Air-Exx did not install? Yes. We service and repair all major brands of heat pumps, package units and split systems in Bullhead City, Fort Mohave and Mohave Valley. We install Trane as a Trane Comfort Specialist.

Air-Exx Heating Cooling and Ventilation LLC is a veteran-owned heating and cooling company serving Bullhead City, Fort Mohave, Mohave Valley and the rest of Mohave County, plus Yavapai County. A live person answers 24 hours a day, Monday through Saturday. Ready to get your heat pump checked before the cold mornings settle in? Call (928) 565-6440 or text (928) 227-8441 to book a heat pump tune-up in Bullhead City.

Straight answers, no surprises

You'll know the price before we start.

You get the service call price on the phone, before anyone heads your way. The diagnostic is credited toward the repair when you approve it.

(928) 565-6440 Request a Quote